complex connector for cable and panel idc (1.27 mm), crimping sequence configuration of product part no. mating connectors: pcl-g96rf( )( )+ (see note #1) mounting screw (for floating connector): pcl-a-sc1 power contacts: pcl-a-m( ) for use with digital switch (see note #2): t55-03m1 (made by cherry co.) idc tool: hand press: locator plate: mlpt-0001a, handpress: rps-k4 (refer to page tool-16) hand crimping tool: kp-pcl-346m( )n extraction tool: pcl-am1 (refer to page tool-8, 9) idc type (power contact: crimping type) male connector for cable and panel pcl-g96rm( )+ pcl-g 96 rm ( )+ ? series name ? no. of contacts: 96 (20 in a block for signal, 68 in a block for signal and 8 in a block for power-supply) type of contact rm: 1.27 mm pitch signal contacts, idc type, with strain relief, male (awg#28 stranded flat cable) type of key (see note #1) blank : none (see note #2) 1 : key type 1 2 : key type 2 ?? note 1: male and female connectors can be mated each other with same key type. however, a female connector without key can be mated with a male connector with any key. further, when trying to mate a male connector without key and a female connector with key, some adjacent contacts may create a short circuit. note 2: an applicable digital switch can be installed in a male connector without key. 5 98.7 85.09 5 cable housing strain relief pos.#1 pos.#2 pos.#19 pos.#20 pos.#67 pos.#1 pos.#p1 pos.#p2 pos.#p7 pos.#p8 pos.#2 pos.#68 (68 contacts in a block) (68 contacts in a block) (20 contacts in a block) (20 contacts in a block) 83.82 94.7 ? 2.54 1.5 103 1.5 30 4.4 6.5 9.5 2.54 ?5 ? 27 3.9 11 10 16 12 22.86 4.8 33.6 96 32 79.8 30 polarity key 24.13 96 101 88.5 6max m2.5 for pcl-a-sc1 mounting screw recommended panel cut-out dimensions (panel thickness: t = 2 mm or less) 29.5 components ? insulator ? power contact signal contact 5 others wire wrapping crimping soldering idc press-in smt through hole
|